Franzen fire doors

single leaf highly fire resistant steel door / flap EI₂120-S_a4-C5

marked with declaration of performance

tested EI₂120-S_a4 / E 120 / EW 60 according to EN 1634-1

test report WFRC 360408 according to EN 13501-2

• as a gate according to DIN EN 13241
• as an external door according to DIN EN 14351-1

U_D-value ≥ 2.7 W/(m²K) according to EN ISO 10077-1

RC2 - classification report no. 45-47/22, PIV-Velbert
RC1 - classification report no. 212 24294, ift Rosenheim

according to DIN EN 1627 ff

up to class 4 according to EN 12207 (± 600 Pa)
expert opinion no. 11-000082-PR01

up to class C5 according to EN 12210 (± 2,000 Pa)
expert opinion no. 11-000082-PR01

up to class 8A according to EN 12208 (+ 450 Pa)
expert opinion no. 11-000082-PR01

according to DIN EN 12211 (up to 5,000 Pa)
expert opinion no. 16-003037-PR01

class 2 (d + e) according to EN 12219 (deflection)

according to DIN EN 16034
hold-open device according to DIN EN 14637

according to DIN EN 14351-1
proven for doors in escape and rescue routes

flush-mounted design FLAT

according to DIN EN 50310, DIN VDE 0100-410 bzw. DIN VDE 0100-540

leaf thickness 68 mm to 69 mm - smooth double-walled
plate thickness 1.0 mm to 1.5 mm

thin rebate design

• optional full-face glued and pressed with cover plate,
  thus particularly smooth and even door leaf

Thelesol® 120 fire protection strips at the door edges

securing pins

corner frame

frame-system "ZNG"
with elastic rubber seal

• optional enclosing frame
• optional block frame

required for smoke control, acoustic performance, air tightness

• optional lowerable floor seal RSI
• optional time-delayed closing floor seal RSI-V
  (not for acoustic performance, increased airtightness, resistance to wind load, watertightness)
• optional sliding seal / grinding seal

2/3-part KO door hinges
with patented easy-running bearings as easy running doors

• optional door hinge with 3D adjustment
• heavy-duty hinges available on request

• optional any approved handle set according to EN 1906 resp. EN 179
• optional panic bar handle or push bar according to EN 1125

single locking according to EN 12209, depending on version multi-point locking
profile cylinder prepared (cylinder on-site)

• optional panic locking according to EN 179 resp. EN 1125

door closer according to DIN EN 1154

• optional spring hinge for smaller doors / flaps

• in masonry (thk ≥ 175 mm)
• in concrete (thk ≥ 140 mm)
• in aerated concrete (thk ≥ 150 mm)

• optional blunt installation in soffit
• approved for installation at great heights (installation not at floor level: height on one or both sides > 500 mm above ground level - e.g. as manhole door/flap) with lower fire and smoke seal - also thresholdless

• lock control
• automated opening
• motor locks ( also in 3-way locking)
• powder coating in RAL colors
• prison cell doors (special locking and food flap)
• special solutions according to request and customer requirements